Viking Valves & Systems

Viking Valves & Systems are designed as a fire safety shut-off valve for use on burning equipment. The valve is installed in the oil supply pipeline outside the building with the sensor mounted firmly inside the appliance above the burner.

Deluge-Valves

Viking Valves & Systems

Wet Pipe Systems

Model E-1 / F-1 EasyRiser® Swing Check Valve & Trim

011189The Viking Easy Riser® Swing Check Valve is a general purpose rubber-faced check valve approved for use in fire service systems. The valve is for use in wet system risers, preaction system risers and wherever a check valve with a drain connection and gauge connections can be utilized. When used with a flow switch on wet pipe systems not requiring a mechanical alarm, the Easy Riser® Swing Check Valve may replace an alarm check valve.

Technical Data Sheets

Model J-1 Alarm Check Valve

The Viking Model J-1 Alarm Check Valve serves as a check valve by trapping pressurized water above the clapper and preventing reverse flow from sprinkler piping. The valve is designed to initiate an alarm during a sustained flow of water (such as the flow required by an open sprinkler) by operating an optional water motor alarm and/or alarm pressure switch.

Technical Data Sheets

Alarm Check Valve Vertical Trim (Model J-1)

 

Technical Data Sheets

Alarm Check Valve Horizontal Trim (Model J-1)

Dry Pipe Systems

Model F-1 Dry Valve

The Viking Model F-1 Dry Pipe Valve is a latching differential valve used to separate the water supply from the dry pipe sprinkler system. The valve combines a positive latching clapper and air plate assembly, with a differential air to water seat design. The latching clapper and air plate assembly provides a positive mechanical seal for the air pressure in the dry pipe system.

Technical Data Sheet

———————————————————————–

Model F-2 Dry Valve

The Viking Model F-2 Dry Pipe Valve is a latching differential valve used to separate the water supply from the dry pipe sprinkler system. The valve combines a positive latching clapper and air plate assembly, with a differential air to water seat design. The latching clapper and air plate assembly provides a positive mechanical seal for the air pressure in the dry pipe system.

Technical Data Sheet

———————————————————————–

Dry Valve Trim (Model F)

Rate this page